Safety: mains-powered smart bulbs and fittings should be installed to the manufacturer's instructions, and anything involving fixed wiring is a job for a licensed electrician in Australia. Keep hubs and bridges on your IoT network and do not expose them to the internet.
The pieces
- TRÃ…DFRI gateway: the older hub. Home Assistant's TRÃ…DFRI integration talks to it locally and controls the Zigbee lights that are connected to it.
- DIRIGERA hub: the newer hub. IKEA's Australian page says it is not needed for Matter devices, but is recommended because it connects all IKEA devices (new and old) and works as a Matter controller. It also acts as a Matter bridge so older Zigbee-based devices keep working in other platforms.
- New Matter range: IKEA's page describes 21 new Matter-enabled devices, with many of the new sensors using Thread. The Matter devices are added by scanning a QR code in the IKEA Home smart app or another Matter app.
GadgetGuy reported in November 2025 that IKEA's local PR team said the new range would launch in waves: sensors from January 2026, then Kajplats smart bulbs from around April 2026, with no date given for plugs and remotes. Those dates were an announcement, so check the IKEA Australia site for what is actually in stores now.
Which route should I pick?
- I want the simplest setup: DIRIGERA plus the IKEA Home smart app, then add Matter to another platform if needed.
- I run Home Assistant and have the old gateway: the TRÃ…DFRI integration works with the gateway. Per the docs, the remotes, shortcut button and motion sensor only report battery state through this integration, so use ZHA, Zigbee2MQTT or HomeKit if you want to automate with them. The docs also say the app's groups are not imported, so use Home Assistant light groups instead.
- I run Home Assistant and have DIRIGERA: the TRÃ…DFRI docs say there is no dedicated core integration for DIRIGERA, and suggest the HomeKit device or Matter integrations. As of hub version 2.615.8 (September 2024) the docs list lights, smart plugs, blinds, remotes, motion sensors, open/close sensors, air purifiers and air quality sensors through the Matter bridge.
- I run Zigbee2MQTT: many IKEA Zigbee devices pair directly to your coordinator without any IKEA hub. The pairing project post in this forum has the steps.
- Give the gateway or hub a DHCP reservation, and put it on an IoT VLAN. Home Assistant needs to reach it, so allow only that.
- Do not port-forward anything. Remote access should be through a VPN or the vendor's app.
- If you use the gateway, the security key is on a sticker underneath it. Do not share photos of it online.
- Keep firmware updated, and expect to repeat setup in Home Assistant after a gateway firmware update (see the docs).