Safety: the panel must keep working with this switched off. If the system is monitored, tell the monitoring company. Do not enable the cloud (SWAN) option and do not expose the module to the internet.
What you need
- Home Assistant OS or Supervised (for the add-on). With Home Assistant Container or Core, run PAI with Docker or Python instead and use the same MQTT integration.
- An IP150 (or IP100) module with a firmware range the wiki says is supported for local connection, and a DHCP reservation for it.
- The panel's PC password (from BabyWare) and the IP module's password.
- An MQTT broker. The official Mosquitto broker add-on is the usual choice.
- Install and start the Mosquitto broker add-on. Create a dedicated broker login for PAI, following the add-on's instructions.
- Disconnect BabyWare and any other client from the module (it generally allows one PC session at a time).
- In the add-on store add the repository https://github.com/ParadoxAlarmInterfac ... repository and install the stable Paradox Alarm Interface add-on.
- In the add-on Configuration tab, merge in the settings shown in step 4 below (they follow the wiki's minimal local-IP example, with placeholders).
- Quote numeric-looking passwords to keep leading zeros. Clear any SWAN settings (Site ID and email) so that it uses the local connection. Note that 127.0.0.1 inside the add-on is the add-on itself, not the Mosquitto add-on.
- Start the add-on and read its log for a successful panel login and broker connection.
- In Home Assistant, check that the MQTT integration is set up and the Paradox entities appeared via discovery.
Code: Select all
CONNECTION_TYPE: IP
IP_CONNECTION_HOST: 192.168.40.30
IP_CONNECTION_PORT: 10000
IP_CONNECTION_PASSWORD: 'your-ip-module-password'
PASSWORD: 'your-pc-password'
MQTT_ENABLE: true
MQTT_HOST: core-mosquitto
MQTT_PORT: 1883
MQTT_USERNAME: pai
MQTT_PASSWORD: 'your-broker-password'
MQTT_HOMEASSISTANT_AUTODISCOVERY_ENABLE: trueWalk each zone and check the binary sensors. Test arm and disarm with someone at a keypad. Check time sync and trouble states over a few days.
Hardening and good habits
- The wiki says Babyware access through PAI is disabled by default. Leave it off unless you need it, and restrict it to trusted clients.
- Give the broker account only the topics PAI needs, and do not expose the broker to the internet.
- The wiki warns that the add-on cannot configure some advanced settings (for example module PGMs), because add-on options are stored as JSON. In that case use standalone Docker or Python.
- Do not automate disarm from a presence sensor or a voice assistant. Run only one PAI instance per panel connection.