Safety and compliance: the panel must keep working on its own if your integration, network or broker fails. If the system is monitored, tell the monitoring company before connecting anything. In Australia, intruder alarm installation and maintenance is covered by AS/NZS 2201.1, and installer licensing varies by state. Serial connections involve the panel's low-voltage logic lines, so power it down first and use proper level conversion, or have your installer do it.
What PAI is
PAI is middleware that connects to a Paradox panel and exposes it by MQTT, so it works with Home Assistant, openHAB, Homebridge and anything else that speaks MQTT. The README says it supports MG, SP and EVO panels, over a serial port or through an IP100 / IP150 module. It reports very stable support for Magellan, Spectra and EVO panels.
Connection options
From the wiki's Connection methods page:
- Native serial: a USB serial adapter, or a level-shifted interface that suits your hardware. Typical baud rates: 9600 for Spectra and Magellan, 38400 or 57600 for EVO.
- IP100 / IP150: PAI uses the module's PC connection protocol. Whether it works depends on the IP150 module firmware (the wiki lists historical ranges). It says to prefer a local connection.
- Serial over TCP: a transparent bridge such as an ESP32. It has no IP150-style authentication, so keep it on a trusted network.
- PRT3: the ASCII printer module interface, with different features.
The cloud (SWAN) option: avoid
For some IP150 firmware you can connect via the Paradox cloud (using a Site ID and email). The PAI README and wiki do not recommend this, citing published security research in this repository. Prefer a local IP connection or serial.
The EVO firmware warning
Older PAI documentation warned against upgrading EVO firmware to 7.50.000 or later, since Paradox introduced serial encryption. The current wiki says PAI 3.8.1 supports the full-AES serial protocol used by supported EVO firmware 7.50 and later (a SERIAL_ENCRYPTED option), but also says not to upgrade firmware solely to enable it, because firmware changes may be irreversible and support is model-specific. Check the compatibility page first. A separate note says the MG6250 support is experimental only.
Network safety
- Change the IP module's default password and keep it, and the PC password, in a password manager.
- IP modules generally allow one PC session at a time. Disconnect BabyWare before starting PAI.
- Put the module (or bridge) on an IoT VLAN, with a DHCP reservation, reachable only from the machine running PAI. Do not port-forward.
- Run only one PAI instance against a panel connection.